Sansonic HNB-B Guía de instalación descargar pdf (Pagina 32)

SonicDevices n 9950 Baldwin Place, El Monte CA 91731 n (T) 626-454-8169 n (F) 626-433-1079 n (W) www.sonicdevices.net

Installation and Technical Application Guide

igital multimedia mixer for Audio, Video and Wireless applications

Page 32

7.5 SM1 Hand-Held Student Microphone - Activation and Pairing (Channel 2)

Receiver

HB-Rx Receiver Module

(close-up of Channel 2 - Student Microphone)

NOTES:

HNB-C microphones are

factory 'paired' and should

connect when power is

pressed ON showing a

STEADY blue LED

condition.

ALL SM1 hand-held

microphones can be 'paired'

to ANY HNB-C unit in under

ten (10) seconds.

Only (1) SM1 microphone can

be operational per each

HNB-C unit.

HNB-C microphones should

be fully charged to insure

proper operation.

ON / OFF

Slide switch

Pairing switch

SM1

Student Microphone

SLIDE SWITCH

‘ON’ =UP

LED (BLUE/

RED)

IR PAIRING

SWITCH

OFF

Step 1: Press the power (PWR) button on the

HB-Rx receiver module for Channel 2.

ower ON = Blue LED flashing.

NOTE: Only the SM1 microphone can

operate on Channel 2.

Step 2: Press the ON/ OFF SLIDE SWITCH of

the SM1 student microphone to ON.

ON = Blue LED flashing or Blue LED

steady.

Tip: if the LED's on both units (HB-Rx and

transmitter) continue flashing then proceed to

Step 3 'Pairing'. If the LED's are solid (ON, but

not flashing) then the units linked themselves

and are ready to broadcast. Go to Step 5

'Volume' in section 7.4.

Step 3: With the SM1 ON/OFF SLIDE SWITCH

in the ON (up) position, depress the pair-

ing switch inside the hole at the bottom of

the slide switch for 2-3 seconds until the

LED begins flashing blue/red. While the

LED is flashing, place the SM1 micro-

phone within 1 meter / 3 feet of the HB-

Rx module IR lens which is also set in

the pairing mode. In less than 4-6 sec-

onds, both units will start a FAST FLASH

mode ending in a SOLID STEADY Blue

on both LEDs. The units are successfully

'Paired' and broadcasting can begin.

Paired = Blue LED solid.

Go to Step 5 'Volume' in section 7.4

Note: a paper clip or similar 'pin' type device can

be used to depress the IR pairing switch.

SM1

close-up of Student Microphone switch

LED-IR lens

Blue / Red

Sansonic HNB A+B+C installmaULb:Sansonic HNB A+B+C installmaULb 6/29/11 6:40 PM Page 32

1 2 ... 27 28 29 30 31 32 33 34 35 36

Comentarios a estos manuales

Sin comentarios

Sansonic HNB-B Guía de instalación Pagina 32

Comentarios a estos manuales

Relacionado con productos y manuales para Amplificadores de audio Sansonic HNB-B